At the bottom of the page, click SAVE & APPLY.

For the IPv4 address, enter 10.10.10.1 (it has to be a different subnet than the hotspot and I like this numbering scheme).

On the left side, click on Network and then Interfaces.

Click SAVE & APPLY at the bottom of the page.

Click on “Go to password configuration…”.Use the default WiFi password of rooter2017. Select the ROOter SSID on your computer.

This is going to vary based on the current firmware on the router. I then flashed the firmware onto the router.I grabbed firmware for the HooToo TripMate Nano router.There should be very few, if any, changes for different LTE modems. There are a large number of steps, but they’re pretty simple. Worst case is that I’d brick the router and this exercise would be over.Īfter a bit of fiddling, I got everything working. There happened to be firmware for a router similar to my portable router, so I decided to give it a try. The forums talking about the Mobley mentioned router firmware called ROOter that supports various routers and modems. Now I had a mobile hotspot and a router that maybe I could put together to be a WAN failover. I’ve been reading forums about the Mobley and saw that the Mobley could be tethered to a router and not just used as a hotspot. I had some success with it, but ultimately gave up and have just been using it as a battery for other devices. This is a great addition for a enterprise class router, but overkill for my needs.Ībout a year ago I purchased a HooToo Travel Router to experiment with setting up a VPN when I travel. One of the features of the latest UniFi Controller is the ability to turn an unused Ethernet port on the USG to be a WAN failover. The cost to set this up could never be justified for my home setup. I’ve never pursued setting this up as my Internet connection has been quite reliable with downtime measured in hours over the last few years. For many years, I’ve been intrigued about routers that have cellular backup to maintain connectivity when the primary Internet does down.

Set up a usb voip for mac